A Review Of alliant rl-26

A Review Of alliant rl-26

Blog Article

To sum it up, just start out checking the price of the powder to start with. In between H-110 and gain 296 (which happen to be equally exactly the same powder), the H-one hundred ten most time is definitely the less expensive powder. On 300mp, it hard to find it inside a 8lb jug, and Unless of course you will discover it inside a 8lb jug, or your vendor will cut you a rate on 8-1lb cans for the 8lb jug cost, then H-one hundred ten is frequently the cheaper powder that you could come across rather.



The equilibrium is for powder. Considering that your crimp goes in to the wad column/hull your powder is just not cumbersome adequate which enables the shot/wad column to established as well deep within the hull. Since you have intense restrictions with component availability from the 410 gauge its probably needed to change powder so that you can solve the situation.

Thank you very much for responding to my question. I a short while ago acquired a different Spolar. I didnt have this issue with my older Spolars.

Having said that, whichever situations utilized, H110/W296 can get you for a longer time case lifetime than every other 410 powder I know of.

LilGun burns up my hulls far too quickly as does Alliant 410. I have also experimented with pretty much all the things else. Don't remember my gripes Along with the Many others, but I have been utilizing H110 a long time and normally have already been happy with it.

I think it is always that ignition is ever more unreliable because it gets colder but didnt press for specifics at time so can't be absolutely sure. I haven't played with it considering the fact that this discussion as I shown it below "Why hassle if the same could be had from 2400 and we understand how it behaves."




Winchester 296 and Hodgdon one hundred ten are the same powder with a special label. You may get by just good with no at any time weighing a shot demand or reaming a bushing; Pretty much nobody does both.

So In the event alliant 410 your not about to ream the shot bushing and just Permit it throw 214grs of shot, then up the powder bushing to some .300" ID bushing from the HS loads. This extra minimal little bit of powder will provide the shell the necessary volume to fill it thoroughly, Therefore the shot will not rattle immediately after crimp.

The person accessing This great site assumes the potential risk of Safe and sound loading practices. Failure to take action could bring about critical personal injuries (or death) and/or property injury.

The information shown on This website, including ballistic data, was derived from tightly controlled laboratory disorders.

Alliant Powder’s new 410 flake powder is the only real flake powder especially personalized for that stringent needs of.

Built by showin




Next, the see that Lil Gun kills hull everyday living. I get a number of reloads with Lil Gun in AAHS hulls. I also like 296/H110 - but just stating, Lil Gun is a superb powder at the same time. And it patterns effectively in my gun - as well as any .410 powder.

The shell are definetly less than powered. Once again I'm applying Alliant Green Dot powder as advised from other forums which i study. look at more info I am open to any ideas or advice on these loads.